Water HeaterRCCB (Residual Current Circuit Breakers)

Instant water heaters: DC pump, AC pump or no pump?

The pump decides how the shower feels. Here is how to choose, and what your wiring has to handle.

2 min read5 steps

Ask us a question

01How an instant heater works

There is no tank. Water passes through a heating element and comes out warm in seconds. You never run out, but one heater can only warm so much water at a time. One heater suits one bathroom, and two showers at once will feel weak.

Rubine Cetus RWH-CE521D-SCG/SSB, 4.25 kW Instant Water Heater with DC Pump
Key point

No pump: simplest, works well when your water pressure is already good.

02Non-pump models

A non-pump heater uses the pressure from your water supply. If the shower is already strong, this is the simple choice, with fewer parts. If the water pressure is weak, the shower will stay weak, and a very low flow can stop the heater from switching on. The maker lists a minimum pressure and flow on the datasheet.

EPS (Utama Switchgear) NGPL Residual Current Circuit Breaker (RCCB), 2P and 4P, 16 A to 100 A
Key point

A pump boosts weak pressure. A DC pump is usually quieter and smoother than an AC pump.

03Pump models: DC or AC

A pump heater pushes the water along, so a weak supply feels stronger. This helps on upper floors or where the water tank is not high. A DC pump is usually quieter and can adjust its speed smoothly. An AC pump is simpler and tends to be louder. Our range lists DC pump and non-pump models.

Rubine Cetus RWH-CE520N-SSB, 4.25 kW Instant Water Heater, Non-Pump
Key point

Our models run 3.6 to 4.25 kW, about 15 to 18 A. Give the heater its own circuit.

04Check the power and the wiring

Our instant heaters are rated about 3.6 to 4.25 kW. At 240V that is roughly 15 to 18 A, which is a lot for an ordinary socket circuit. The heater should be on its own circuit with its own breaker, and the usual cable is 4 mm² or bigger. Many homes also fit an RCCB for the bathroom. Earthing must be right. This is fixed-wiring work for a registered electrician.

Hager Residual Current Circuit Breaker (RCCB) 2P, 16 to 63 A
Key point

Wiring, earthing and the breaker are for a registered electrician.

05Where and how to fit it

Fit it where the maker says, away from direct splashing, with the hot and cold pipes connected the right way. Plumber and electrician should both read the manual. Do not run the heater without water flowing through it. Pick a colour and a model, then WhatsApp us your bathroom photo and pressure situation and we will point you to a fitting one.

Rubine Stella RWH-STE351D-BCB/BPM, 3.8 kW Instant Water Heater with DC Pump

This guide is general advice. Fixed wiring and distribution board work should be done by a qualified electrician.

From this range

See all Water Heater

Next guides

Come to the counter

D-One Electrical is in Taman Bukit Indah, Iskandar Puteri, minutes from the Second Link. Bring the model number or a photo and we'll find it.

No. 11, 11A & 11B, Jalan Indah 15/2, Taman Bukit Indah, Iskandar PuteriMon to Fri 8am to 5pm, Sat 8am to 4pm. Closed Sundays and public holidays.

Prices change with stock and quantity, so we quote on request.

WhatsApp for a quote