LED COB StripCabinet Lighting SystemLED Drivers & Power Supplies

24V COB strip kits for wardrobes and kitchen cabinets

A strip, a 24V power supply and a switch. How to put the set together so it is bright, safe and easy to service.

2 min read5 steps

Ask us a question

01What is in a kit

A COB strip is a soft strip with a dense line of tiny LEDs under one smooth coating, so you see a continuous line of light instead of dots. A cabinet kit has the strip, a 24V power supply, and a way to switch it: a door controller, a hand-sweep sensor or a touch dimmer. Extension wires join the parts.

Prestige LED Strip Aluminium Profile
Key point

A kit is three parts: the COB strip, a 24V power supply, and a switch or sensor.

02Why 24V

24V DC is low voltage, so only the power supply touches the mains. The strip, switch and wires in the cabinet are on low voltage only. It is also easier to run a longer strip on 24V than on 12V. The strip and the supply must share the same voltage, so check the label before you buy: a 24V strip needs a 24V supply.

DCL Cabinet Power Supply 24V DTY-CPS (60W, 100W, 150W)
Key point

Add up the strip watts, then add 20%. Pick the next power supply size up.

03Size the power supply

Strip watts per metre are on the datasheet. Multiply by the length in metres, then add 20% as headroom so the supply is not running flat out. For example 3 m of an 8.5W per metre strip is 25.5W, and with 20% that is about 31W, so a 36W or 60W supply is the right range. The calculator on our site does this for you.

Prestige Rainproof Power Supply 12V 24V 400W
Key point

Keep the strip and power supply on the same voltage. 24V strip needs a 24V supply.

04Layout and cutting

Cut only at the marked cut points on the strip. Keep one run to the maker's maximum length, because a long run gets dimmer at the far end. For a wardrobe, run the strip along the front edge inside the top panel so the light falls on the clothes. For a kitchen, fix it under the wall cabinet near the front, to light the counter and avoid glare in your eyes.

Prestige LED Strip
Key point

Leave the power supply where you can reach it. Do not bury it.

05Colour and service

Choose warm white (3000K) for a cosy look, neutral (4000K) for kitchens and daylight (6500K) for a crisp, bright finish. Keep the same colour across one cabinet so the light matches. Put the power supply where there is some airflow and where you can open it later. Fixed mains connections go through a registered electrician.

DCL Cabinet Sensor Switches: Gated Induction, Hand Sweep, Touch Dimmer

This guide is general advice. Fixed wiring and distribution board work should be done by a qualified electrician.

From this range

Prestige LED Strip
Prestige

LED Strip

PLS-5050 · PLS-2835

See all LED COB Strip

Next guides

Come to the counter

D-One Electrical is in Taman Bukit Indah, Iskandar Puteri, minutes from the Second Link. Bring the model number or a photo and we'll find it.

No. 11, 11A & 11B, Jalan Indah 15/2, Taman Bukit Indah, Iskandar PuteriMon to Fri 8am to 5pm, Sat 8am to 4pm. Closed Sundays and public holidays.

Prices change with stock and quantity, so we quote on request.

WhatsApp for a quote