House Wiring CableTwin Flat CableMCB (Miniature Circuit Breakers)

House wiring cable sizes: what goes where

A simple guide to the usual cable size for lights, sockets and a water heater, and why the breaker must match the cable.

2 min read5 steps

Ask us a question

01Start with the circuit, not the cable

A house is wired in circuits: one for lights, one or two for sockets, then separate ones for the water heater and each air-conditioner. List the circuits first. Each circuit gets its own cable size and its own breaker at the distribution board. Do not share one thick cable between everything.

Tai Sin PVC Insulated Cable, 1.5 mm², Single Core
Key point

Lights usually use 1.5 mm². Normal 13A socket circuits usually use 2.5 mm².

02The usual sizes

These are common rules of thumb, not a design. Lighting circuits: 1.5 mm². 13A socket circuits: 2.5 mm². Instant water heater (3.6 to 4.25 kW, about 15 to 18 A): 4 mm² or bigger, on its own circuit. Air-conditioners and cookers depend on their rating, so read the label and ask. The standard behind Malaysian house wiring is MS IEC 60364, and Suruhanjaya Tenaga publishes guidance for homes.

Evolt PVC Twin Flat VDE Cable, 23/0.15 x 2 Core
Key point

A water heater of 3.6 to 4.25 kW usually needs 4 mm² or bigger, on its own breaker.

03Match the breaker to the cable

The MCB is there to stop the cable overheating. So the breaker rating must be at or below what the cable can carry. If a breaker keeps tripping, the answer is not a bigger breaker. Check the load, check for a fault, or run a thicker cable. Your electrician decides the final breaker size.

EPS (Utama Switchgear) JMS MCB 6kA Miniature Circuit Breaker, 1P, 2P, 3P, 4P
Key point

The breaker protects the cable. Never fit a bigger breaker on a thinner cable.

04Long runs and tight spaces

The longer the cable, the more voltage it drops, and the hotter it gets in a crowded conduit or ceiling. For a long run, a hot ceiling or many cables in one trunking, go up one size. It costs a little more at the start.

Tai Sin PVC Insulated Cable, 2.5 mm², Single Core
Key point

Long runs lose voltage, so ask your electrician to go up a size.

05Before you buy

Look for the standard and the SIRIM label printed on the cable, and check the size marking on the coil. Buy single core for conduit and trunking, twin flat for surface wiring where allowed. Fixed wiring must be done and signed off by a registered electrician. Tell us the circuit and the length and we will help you count the coils.

Techma VDE Twin Flat Cable, 42/0.15 x 2 Core, 250/400 V

This guide is general advice. Fixed wiring and distribution board work should be done by a qualified electrician.

From this range

See all House Wiring Cable

Next guides

Come to the counter

D-One Electrical is in Taman Bukit Indah, Iskandar Puteri, minutes from the Second Link. Bring the model number or a photo and we'll find it.

No. 11, 11A & 11B, Jalan Indah 15/2, Taman Bukit Indah, Iskandar PuteriMon to Fri 8am to 5pm, Sat 8am to 4pm. Closed Sundays and public holidays.

Prices change with stock and quantity, so we quote on request.

WhatsApp for a quote